Grannas Racing Honda / Nissan Bellhousing Offset dowel pin set (14mm)

Grannas Racing Honda / Nissan Bellhousing Offset dowel pins. Used when you have more than .005 runout on your bellhousing index.

These high quality offset dowels were designed in house to be superior to the competition. These dowels have a heavier wall thickness and a flathead screwdriver slot to turn them. This slot also helps visually align to the angle of your bell housing offset. These will fit any 14mm diameter dowel hole, but were designed specifically for Honda F20/F22 and Honda K20/K24 and other honda applications that use 14mm dowels. No shortening or other modifications needed for honda applications.

If you are trying to use these on a Z32/300ZX or RB or other 14mm Nissan, you may need to shorten these, as some Nissan stuff the block depth is not as deep... but that is a simple mod to do yourself with a cutoff wheel and vise/pliers.

When selecting an offset dowel, the offset dowel should be roughly half the total runout you have. See chart below

WHAT SIZE DO YOU NEED????

Out of index range: .005 to .012
USE SIZE .004

Out of index range: .012 to .020
USE SIZE .008

Out of index range: .020 to .028
USE SIZE .012

Out of index range: .028 to .036
USE SIZE .016

Out of index range: .036 to .044
USE SIZE .020

TECH TIP:
To remove your stock dowels, i recommend soaking them in a penetrating oil and let them sit overnight. Use a pair of heavy duty vice grips and slowly work them back and forth. If the get tight, heat applied to the block around the dowel may be needed

TECH VIDEO: